Even if the naked eye can not see the smile dust into the forklift bearings, will increase the IKO bearing wear, vibration and noise.
Do not allow strong stamping, do not allow direct hammering forklift bearings, do not allow the transmission of pressure through the rolling body.
Try to use special tools and avoid using cloth and short fiber and so on.
Prevent rusting of forklift bearings
When picking up the forklift bearings directly by hand, wash off the sweat on your hands fully and apply high quality mineral oil before operation, especially pay attention to rust prevention in rainy season and summer.
However, under certain special operating conditions, forklift bearings can obtain a longer life than traditionally calculated, especially under light loads. These special operating conditions are when the rolling surfaces (tracks and rolling elements) are effectively separated by a lubricant film and the possible surface damage caused by contaminants is limited.
Forklift bearing lubrication, first open the cover and observe the wear of the separating bearing, if it is confirmed that the bearing is not damaged or the wear is not over the limit, then remove the clutch pedal, adjust the top lever, make the separating bearing and its seat return to the last position, use the pointed grease gun to fill the hole of the bearing seat with grease until the bearing has oil overflow, then turn the bearing slightly and fill it with grease again, repeat the above work until the bearing is surrounded by a little Grease overflow, and then make the bearing rotation, observe the amount of oil, such as feeling the bearing rotation resistance, prove that the bearing has been filled with grease. Then remove the small amount of grease overflowing from all parts of the separation bearing seat, and readjust the position of the separation bearing.
Forklift bearings are different from general common bearings, its workmanship, bearing material and performance are better than general bearings. Industrial handling vehicles are widely used in ports, stations, airports, freight yards, factory workshops, warehouses, distribution centers and distribution centers, etc. They can also enter the ship’s hold, carriage and container for loading and unloading of palletized goods and handling operations. It is an indispensable equipment for pallet transportation and container transportation.
