LOGO

This is how linear rail work?

The role of linear rail movement is used to support and guide the moving parts, according to the given direction to do reciprocating linear motion. Has a higher load than linear bearings, while can bear a certain torque, can achieve high precision linear motion under high load.

linear rail can be regarded as a guide, is by the steel ball in the slider and the guide between the infinite rolling cycle, so that the load platform along the guide easily linear movement with high precision, and the coefficient of friction to the usual traditional sliding guide 1/50. at the same time between the slider and the guide end system unit design, so that the linear rail while bearing the load in all directions, such as up and down.

The difference between linear guide and flat guide.

linear rail rail and flat guide rail, there are two basic components; one as a guide for the fixed elements, the other is a moving element.

The basic installation steps of the linear rail.

1, check the assembly surface

2, set the reference side of the guide and install the benchmark side of the step relative

3, check the position of the bolt, confirm the correct position of the screw hole

4、Pre-tighten the fixing screws, the guideway reference side and the installation step side of the close contact

5、Final tightening of the mounting bolts

6、Tighten the solid screws of the slider in turn

Second, the installation method of linear guide benchmark guide vice.

1, the use of U-type chuck will guide the reference side and the side of the installation step tightly clamped, and then tightened in the place with a fixed bolt, from one end, in turn, the guide fixed.

2, no installation step, one end of the guide will be fixed, the gauge needle against the reference side of the guide, to the linear block to return as the reference, from one end of the guide to start reading the pointer calibration straightness, and the guide will be fixed in turn.

Third, the linear rail is not the benchmark guide vice installation method.

1, the use of U-type chuck will guide the benchmark side and the installation step side of the tight clamping, and then tightened with a fixed bolt in the place, from one end, in turn, the guide fixed.

2, no installation step, one end of the guide will be fixed, the gauge needle against the reference side of the guide, the linear block to return as the reference, from one end of the guide to start reading the pointer calibration straightness, and the guide will be fixed in turn.

Fourth, when the linear rail sturdy bolt, it is recommended to use a constant torque wrench for.

Fifth, the ball linear rail vice protection and lubrication.